![]() ![]() ![]() The amount of proposed penalties varies, depending on the type of violation: Willful, Serious, Other-Than-Serious, Failure-to-Abate, and Repeat and on the employer's size, good faith, previous history of violations, and the gravity of the violation. Response: During the course of an inspection, if an employer is found to expose his or her employees to fall hazards which could result in serious injuries, citations would be issued along with proposed penalties. Question 2: Can OSHA give me information on fines and the circumstances surrounding the fines, if a plant is found to be violating the fall arrest guidelines set forth by OSHA? A copy of the relevant portion this Federal Register is enclosed. You should also be aware that, as part of a rulemaking to revise Subpart D of, OSHA has proposed the inclusion of a fall protection requirement that would apply to work platforms used in conjunction with powered industrial trucks. Although the ASME standard calls for the use of body belts, OSHA strongly encourages employers to use body harnesses in place of body belts. Section 4.17.2(c) of ASME 56.1-2000 requires that whenever an operator-up high lift truck is used to elevate personnel, restraining means such as railings, chains, cable, body belt(s) with lanyard(s), or deceleration devices, etc. Industry consensus standards, such as ASME B56.1-2000 Safety Standard for Low Lift and High Lift Trucks would be taken into consideration by OSHA when determining whether a hazard is "recognized" and that there is a feasible means of abating such a hazard. However, in the absence of a specific standard, OSHA can enforce Section 5(a)(1) of the Occupational Safety and Health Act (OSH Act) - which requires employers to protect employees from serious recognized hazards. 178, does not have provisions that require either the use of a body harness or safety belt to protect personnel against falls from elevated platforms. ![]() Response: OSHA's powered industrial trucks (PITs) standard, contained in. Question 1: In regards to the use of fall arrest equipment and the use of body belts, do OSHA regulations require that a body belt be attached to a lanyard and used to protect personnel against falls from elevated "operator-up" high lift truck platforms, or do the standards state that a 5-point harness must be worn as a part of a fall arrest device? Your paraphrased questions and our responses are provided below: This letter constitutes OSHA's interpretation only of the requirements discussed and may not be applicable to any questions not delineated within your original correspondence. Verify that the design of the additional platform prevents the risk of falls: for example, presence of guardrails on the open sides.Īrticles must never rest on the guardrails, unless they are designed for this purpose.Ĭontact WORK SAFE Training Inc - you for your April 13 letter to the Occupational Safety and Health Administration (OSHA) regarding the use of body belts and the harnesses on elevated platforms of powered industrial trucks. Implement measures for complying with the maximum permitted load capacities at all times, since sudden braking and changes in direction can result in off-centering of the load and even in overturning of the fork lift truck.Įnsure that no pallet or merchandise extends excessively over the edge of the pallet rack, thus hindering upward and downward movements. – Initiate a turn only when the operator’s station is lowered. When pedestrians are present, station off the work area of the order picking truck. Train the operator in the interpretation of the capacity plates on the lift truck, different additional platforms, and safe operating procedures.įall Protection Procedures (wearing of the mandatory safety harness). Ensure that the order picking truck has a second capacity plate that takes into consideration the weight of the additional platform. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |